Furniture maintenance

Cabinet maintenance


Vacuum cleaner small brush cloth drier screwdriver
Maintenance steps/
1, to keep doors clean, no debris in orbit, dust. Cleaning available half wet rag and wipe the Cabinet, doors, do not use corrosive cleaning agents. Tracks dust with a vacuum cleaner or small brush to clean, frames, levers and other metal parts with a dry cloth.
2, heavy and sharp drop should be prevented to touch track, scratch the Cabinet body and door panels, Cabinet edges cannot touch water and other liquid solvents, so as not to appear to fall off the edge.
3, Light sliding door pulley using a long beep is a normal phenomenon, in order to ensure the pulley and lasting smooth quiet please every 2-3 to add some lubricant along the top and bottom pulley on a regular basis.
4, a wooden wardrobe you can usually use a clean cloth to wipe, if there is dirty, you can consider using SOAP and water or a neutral detergent, wipe with a damp cloth.
5, with its breathable, or regular use of desiccant to avoid Cabinet, damp inside bacteria. Use less chemical fragrances for the wardrobe in addition to taste, because they are likely to cause damage to the material.
6, in room air, or when the weather is too wet, do you regularly open the doors and Windows and ventilation in the closet corner to put small dry lime or other desiccant, prevent moldy cabinets and doors and deformation.
7, wood cabinets should not be placed in direct sunlight places, so as to avoid deformation or cracking wood lighting.
8, at the time of purchase, selection of drawers, cupboards furniture fit high, the best strategy is to reduce the dust.
9, and long time using push doors, dust article may will has minor rubber fell phenomenon, available double rubber bonded can; Xia track positioning device go bit appeared gap, available a word screwdriver alignment positioning device to side Board side push to key sewing at can; push doors appeared tilt phenomenon, to right tilt is adjustable left end of round of "pine" of logo at or right end of round of "tight" logo at.
When using sliding doors, 10, be sure to handle any bulging, protruding should be flat, otherwise it will crash or handle.
Contacts us

Phone: 0371-6639014

Fax: 0371-6639014

Email: zhmdl@msn.com

Web: haveneco.net